| Step | | Procedure & Parts & Tools |
| 1 |
|
MAKE SURE THERE IS WATER IN TANK. PUSH MANUAL SOLUTION VALVE LEVER FORWARD TO OPEN POSITION (ECO MODELS ONLY!)
|
| 2 |
|
CHECK SOLUTION LINE AND DRAIN HOSE AT VALVE (LOCATED ON BACK LOWER LEFT CORNER) FOR LEAKS. MOVE SOLUTION LEVER TO OFF POSITION (ECO MODELS ONLY!)
|
| 3 |
|
LOCATE THE DRAIN HOSES ON BACK OF MACHINE
|
| 4 |
|
PULL THE BLUE CAPPED DRAIN HOSE FROM MACHINE TO INSPECT FOR LEAKS.
|
| 5 |
|
PULL THE RED CAPPED DRAIN HOSE FROM MACHINE TO INSPECT FOR LEAKS
|
| 6 |
|
PLACE HOSES NEAR DRAIN AND REMOVE THE CAPS TO DRAIN THE TANKS
|
| 7 |
|
LOCATE THE 2 TANK BOLTS AT THE FRONT BASE OF MACHINE. REMOVE THE 2 TANK BOLTS ON EACH SIDE OF BASE (SET BOLTS ASIDE)
| Wrench-Allen metric 6.0mm |
|
|
| 8 |
|
LIFT THE FRONT OF THE TANK TO OPEN THE MACHINE AND LOCATE THE BATTERIES
|
| 9 |
|
REMOVE THE BATTERIES FROM THE MACHINE AND LOWER TANK TO CLOSE MACHINE (NO NEED TO REINSTALL TANK BOLTS AT THIS TIME)
|
| 10 |
|
LAY THE MACHINE ON IT'S SIDE AND LOCATE ALL SOLUTION LINES UNDER MACHINE
|
| 11 |
|
VISUALLY INSPECT ALL THE SOLUTION HOSES AND FITTINGS FOR LEAKS. FEEL HOSES TO SEE IF WET.
|
| 12 |
|
STAND MACHINE UPRIGHT, REINSTALL BATTERIES, REINSTALL TANK BOLTS AND FILL TANK WITH WATER AND SOLUTION IF NEEDED
| Wrench-Allen metric 6.0mm |
|
|